Download print version
Test report 7268
The approval
A test mark „DLG-APPROVED for individual criteria“ is awarded for agricultural products which have successfully fulfilled a scope-reduced usability testing conducted by DLG according to independent and recognised evaluation criteria. The test is intended to highlight particular innovations and key criteria of the test object. The test may contain criteria from the DLG test scope for overall tests, or focus on other value-determining characteristics and properties of the test subject. The minimum requirements, test conditions and procedures as well as the evaluation bases of the test results will be specified in consultation with an expert group of DLG. They correspond to the recognised rules of technology, as well as scientific and agricultural knowledge and requirements. The successful testing is concluded with the publication of a test report, as well as the awarding of the test mark which is valid for five years from the date of awarding. The DLG Approved “BTS Cattle1” included joint inspections and behavioural observations during standing up and lying down in three working farms, as well as measurement of deformability on test rigs at the DLG Test Center Technology and Farm Inputs. Data was acquired and analysed in accordance with the “Requirements of the BTS Programme Regarding Deformable Mattresses for Bovine Livestock” (Swiss Ethics Programme Ordinance of 23th October 2013, Annex 6) and DIN 3763:2020-04 (Elastic floorings for cattle and dairy cows walking and rest surfaces – Requirements and testing). Other criteria were not tested.
Assessment – Brief Summary
The Cowhouse cow mattress Friesian Island tested here has been tested in the DLG-Approved Single Criteria Test „BTS cattle“ tested on test rigs for comfort properties.
In three farms, joint evaluations and behavioral observations when getting up and lying down are carried out.
Requierements of the BTS Programme Regarding Deformable Mattresses for Bovine Livestock” (Swiss Ethics Programme Ordinance of 23 October 2013, Annex 6) are fulfilled.
Deformability and elasticity: Class 4 according to DIN 3763.
The product
Description and Technical Data
The Friesian Island cow mattress tested here is an elastic floor covering for high boxes in cubicle stables
- Thickness approx. 69 mm
- ochre top mat:
- Thickness approx. 4.4 mm
- Mattress base:
approx. 65 mm thick foam board, consisting of an approx. 25 mm thick yellow latex foam plate and an approx. 40 mm thick grey PU foam board, wrapped with foil - Installation as web goods
The method
Deformability and elasticity
The deformability is measured in new condition and following permanent tread load using ball penetration tests with a calotte (r = 120 mm) and a penetration force of 2,000 N (corresponding to approx. 200 kg).
Permanent tread load
The permanent tread load is measured on a test stand with a round steel foot in the standard test programme with 100,000 alternating loads at 10,000 N (corresponding to approx. 1,000 kg). The steel foot is adapted to the natural conditions as an “artificial cow foot”. The foot has a diameter of 105 mm and therefore a contact area of 75 cm²; the carrying edge of the hoof is simulated by a 5 mm wide ring on the periphery of the sole that projects 1 mm above the rest of the surface.
Animal health
On at least 3 farms, the tarsi (ankle joints) of all cows by an independent, experienced specialist were examined and the behaviour of the animals when they get up and lay down on the flooring was observed.
In all lying boxes at least 3 months before the examination mats of the product to be tested were installed. The cows to be examined are at least 3 months before the examination kept exclusively in the barn concerned, i.e. they have no grazing.
The test results in detail
Animal health
On 3 farms became the Tarsi (ankle joints) of 119 cows by an independent, experienced specialist in this regard examined and the behavior of the animals when getting up and lying down on the flooring.
The requirements regarding BTS compliance is met.
Deformability and elasticity
In the ball penetration tests in new condition with a calotte (r = 120 mm), penetration depth was 36.8 mm. The resulting calculated bearing pressure of 7.2 N/cm² indicates a low load on the carpal joints when lying down and getting up.
Elasticity was measured following a permanent tread load exerted by a steel foot (contact area: 75 cm²) with 100,000 alternating loads at 10,000 N. Following the endurance test, the penetration depth of the calotte increased from 36.8 mm to 39.4 mm. The bearing pressure decreased from 7.2 N/cm² to 6.7 N/cm² (see Fig. 3). This means that deformability and elasticity slightly increase.
The requirements regarding BTS compliance is met.
Permanent tread load
Wear at the surface and little wear on the foam was observed following exposure to permanent tread load on a test stand with 100,000 alternating loads at 10,000 N. No lasting deformation was observed.
Table 2: BTS Compliance Requirement 3 – Test Results – Assessment
| Requirement for the BTS Compliance 3 | Test results | Evaluation | |
| Animal health | |||
| 1. Tarsi (ankle joints) with crusts or open wounds in % of tarsi examined | max. 25 % | 23.9 % | request fulfilled |
| 2. Tarsi with larger (> 2 cm) crusts or larger (> 2 cm) open wounds as % of Tarsi examined | max. 8 % | 5.5 % | request fulfilled |
| 3. Tarsi with a different, serious change (e.g. increase in circumference) in % of the Tarsi examined | max. 1 % | 0 % | request fulfilled |
| 4. Further, serious physical damage on the animals that pass through the mat could be caused | none | none | request fulfilled |
| 5. Behavioral abnormalities caused by the mat | none | none | request fulfilled |
| Deformability and elasticity | |||
| 6. Penetration depth into the mat in new condition | at least 10 mm | 36.8 mm | request fulfilled |
| 7. Penetration depth into the mat after permanent tread load | at least 8 mm | 39.4 mm | request fulfilled |
3 in accordance with the requirements of the Swiss Federal Office for Agriculture, Bern, of March 2004
The tested Cowhouse cow mattress Friesian Island meets the requirements of the BTS program regarding deformable mats for the animals of the cattle genus (Swiss Ethoprogram Ordinance of the 25 June 2008, Annex 3).
Manufacturer and Applicant
Manufacturer and Applicant
Cowhouse International B.V.
Nobelweg 1
NL-8912 BJ Leeuwarden
Contact:
Phone 0031 88 1012-900
Fax 0031 88 1012-990
info@cowhouse.nl
www.cowhouse.nl
Test implementation
Testing agency
DLG TestService GmbH,
Gross-Umstadt location, Germany
The tests are conducted on behalf of DLG e.V.
DLG test framework
DLG-Approved Test „BTS Rindvieh“1 – BTS Programme „Regarding Deformable Mattresses for Bovine Livestock”(Swiss Ethics Programme Ordinance of 23th October 2013, Annex 6)
Department
Agriculture
Head of Department
Dr. Ulrich Rubenschuh
Test engineer(s)
Dr. Harald Reubold 2
1 Swiss support programme for especially
animal-friendly housing systems
2 Author
Contact us
DLG TestService GmbH - Groß-Umstadt location • Max-Eyth-Weg 1 • 64823 Groß-Umstadt • Tel: +49 69 24 788-600 • tech@DLG.org